Instructions for use
36
Remnants of detergent
are building up in the
detergent drawer.
Water valve not fully opened. Open the water valve fully.
Filter in the screw connec-
tion of the intake hose on
the water valve or on the
unit is blocked.
Close the water valve.
Unscrew the intake hose
from the water tap and from
the unit. Clean the filter.
The rinsing water is
murky.
The cause is probably a
detergent with a high silicate
content.
No negative influence on the
rinsing result, possibly use
liquid detergent.
No illumination when
pressing an additional
program.
The selected additional pro-
gram cannot be combined
with the set program.
Make another selection.
Only the END (FIN)
control panel label is
illuminated.
The washing machine is in
the stand-by mode.
Press any button.
Only the RUN TIME
(TEMPS RESTANT) con-
trol panel is illumi-
nated, a number
between 1 and 19 is
shown in the RUN TIME
(TEMPS RESTANT) dis-
play .
The start time preselection is
counting, the washing
machine is in the stand-by
mode.
If you press any button the
machine will leave the
stand-by mode.
The program sequence
indicator flashes con-
stantly.
Program saving switched on;
the program selector was
accidentally readjusted dur-
ing the washing cycle.
Turn the program selector
back to the original position
(see "Program Saving“).
Problem Possible Cause Remedy