Filter
Top Products
Instructions for use
40
3. While RINSE+ (RINCAGE+) is flashing, release the button SOAKING
(TREMPAGE).
After the flashing stops, the additional rinse is set. It is set until it is
canceled again.
When the additional rinse is set, the indicator RINSE
+ (RINCAGE+)
lights up on the program sequence disply before the program start and
during the additional rinse.
4. If you want to check whether the additional rinse is set:
– Turn the program selector to SHORT SPIN (ESSORAGE DELICAT).
– Briefly press the button SOAKING (TREMPAGE).
The additional rinse is set if RINSE
+ (RINCAGE+) flashes on the pro-
gram sequence display.
Cancel Additional Rinse:
0 1. Turn the program selector to SHORT SPIN (ESSORAGE DELICAT).
2. Keep the button SOAKING (TREMPAGE) pressed for at least 5 seconds.
As soon as the button is pressed, RINSE
+ (RINCAGE+) flashes on the
program sequence display. After 5 seconds, RINSE
+ (RINCAGE+) stops
flashing and lights up constantly for a further 5 seconds.
3. While RINSE
+ (RINCAGE+) lights up constantly, release the button
SOAKING (TREMPAGE).
After RINSE
+ (RINCAGE+) has stopped lighting up, the additional rinse
is cancelled.
3
An additional rinse increases water consumption and the program run
time.
Solution Cooling
It may be necessary to cool down the washing solution before pumping
off in order to avoid thermal damage to plastic drainage pipes.
3
The washing solution is cooled down at the end of the main washing
cycle before pumping off (by incoming cold water).
(This setting is only effective for COTTONS/LINEN (BLANC/COULEURS) at
temperatures of over 40 °C.)
No solution cooling is set when the unit is delivered.