Filter
Top Products
Instructions for use
25
Completion of the Washing Program
Program sequence display
Prior to the start the program steps to be executed are
displayed by the program sequence display. The current
program step is displayed during the washing program.
Multi-display
The expected remaining run time (in min-
utes) until the completion of the program is
shown in the multidisplay.
3
With the automatic program adaption by the control of the washing
machine (quantity and type of washing, balance error recognition, spe-
cial rinsing etc.) counting of the remaining run time can be stopped or
corrected.
Display RESIDUAL MOISTURE%/LOADING%
(HUMIDITE%/CHARGE%)
The following appears alternately at the display:
• The expected residual moisture of the washing
at the end of the program.
This value depends on the set spin speed.
• Load the washing drum (in steps of 10 percent.)
This value is displayed only in COTTONS/LINEN (BLANC/COULEURS)
programs and EASY-CARES/EASY IRON (MIXTES/FACILE A REPASSER).
The washing machine can recognise the load only fifteen minutes
after a program start.
As soon as a value for the load is pending the display alternates
between residual moisture and load.
Overloading of the drum is displayed in values higher than
100 percent (e. g.120).
3
Due to the differences in the fabrics and in the filling quantity the
washing reaches for EASY CARE/EASY IRON (MIXTES/FACILE A
REPASSER) and DELICATES (DELICAT) a lower value for residual damp-
ness than with COTTONS/LINENS (BLANC/COULEURS).
Change the Spin Speed
The spin speed can still be changed or the rinse hold (display 0) be set
during the washing program.
Other settings cannot be changed.