Filter
Top Products
Instructions for use
33
No water runs in.
The fault code
(1 ap-
pears.
Water valve is closed. Open the water valve.
Filter in screw connection of
the intake hose is blocked.
Close the water valve. Un-
screw the hose from the wa-
ter valve, remove the filter
and clean it under running
water.
Water valve is blocked with
limescale or is faulty.
Check water valve and have
it repaired if necessary.
The washing machine
vibrates during opera-
tion or it is on an une-
ven surface.
The transport packaging has
not been removed.
Remove transport packaging
according to the installation
and connection instructions.
The height-adjustable screw
feet are not correctly set.
Adjust in accordance with
the installation and connec-
tion instructions.
There is not much washing in
the drum (e.g. only one
dressing gown).
This does not impair the
function.
The water could not be com-
pletely pumped off before
spinning because the drain-
age hose is bent
or
the solution pump is blocked.
Check the laying of the
drainage hose and eliminate
the bend if necessary, or
clean the solution pump and,
if required, remove foreign
bodies from the pump hous-
ing.
The washing solution
of the main wash
froths up a lot.
Too much detergent was
probably used
Meter the detergent exactly
in accordance with the
manufacturer's information.
Problem Possible Cause Remedy