Filter
Top Products
Instructions for use
25
0 1. After a rinse hold, it is first necessary to pump off the water:
– either press the button START/PAUSE (START/PAUZE, MARCHE/
PAUSE) (water is pumped off and the washing is spun according to
the program which has just run; with the button Spin speed/RINSE
HOLD (GEEN CENTR., SANS ESSOR.), the spin speed can also still be
changed during spinning), or
– turn the program selector to PUMP (POMPEN, VIDANGE) and press
the button START/PAUSE (START/PAUZE, MARCHE/PAUSE) (the water
is pumped off without spinning), or
– turn the program selector to SPIN (CENTRIFUG., ESSORAGE) or SHORT
SPIN (KORT CENTRIFUG., ESSOR. DELICAT), and press the button
START/PAUSE (START/PAUZE, MARCHE/PAUSE) (water is pumped off
and the washing is spun or gently spun).
After the end of this program step, the indicator END (EINDE, FIN)
lights up.
2. Open the filling door.
As soon as the indicator next to the button DOOR/LIGHT (DEUR/LICHT,
PORTE/ECLAIR.) lights up green, the filling door can be opened (not
when the program safeguard is activated, for details see ”Program
Safeguard”).
3. Remove the washing.
4. Turn the program selector to OFF (UIT, ARRET).
5. After washing, pull out the washing detergent drawer slightly so that it
can dry out. Only lean the door against the washing machine so that
the latter can air out.
3
If the display OVER DOSING (OVERDOS., SURDOSAGE)
lights up, too much washing detergent was used in the
washing program just ended. During the next wash, pay
attention to the dosing information of the washing detergent
manufacturer and pay attention to the filling quantity!
Attention! If the washing machine is not used for a long time:
Close the water tap and disconnect the washing machine from the
electricity mains. (Aqua Control water protection with Aqua Alarm
does not operate if the power supply is interrupted.)