Filter
Top Products
19
Use
Opening the door after the programme has started
First set the machine to pause by pressing the button 8. After a few minutes the
symbol
7.5 goes off and the door can be opened.
If the symbol
7.5 is still lit and the door remains locked, this means that the
machine is already heating or that the water level is too high. In this case the
door can not be opened. If you cannot open the door but you need to open it,
you have to switch the machine off by turning the selector dial to
O
. After some
minutes the door can be opened (pay attention to the water level and
temperature!).
After closing the door, it is necessary to select the programme and options again
and to press button
8.
At the end of the programme
The machine stops automatically, the pilot light of button 8 and the symbol 7.5
goes off and a flashing 0 will appear on the display.
If a programme or an option that ends with water still in the tub has been
selected, the symbol
7.5 remains on, a flashing 0 will appear on the display, the
pilot light of button
8 goes off and the door remains locked to indicate that the
water must be emptied out before opening the door.
Follow the below instructions to empty out the water:
● turn the programme selector dial to
O
● select the DRAINING or SPINNING programme
● reduce the spin speed if needed, by means of the relevant button
● depress button 8
● when the programme has finished the display shows a flashing 0. The symbol
7.5 disappears and the door can be opened.
Turn the programme selector dial to
O
to switch the machine off. Remove the
laundry from the drum and carefully check that the drum is empty. If you do not
intend to carry out another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
132963641.qxd 14/10/2008 9.00 Pagina 19