Filter
Top Products
29
Removing transport safety equipment
1
Caution! Before first starting up,
all parts of the transport safety
equipment must be removed.
1. Open loading door
2. Pull off adhesive strips from inside
machine on top of drum.
3. Remove foil hose and polystyrene
padding from the machine.
1 If the appliance was not transport-
ed in an upright position, leave it
to stand for 12 hours before con-
necting it to the electricity supply
and using it for the first time, so
that the oil can flow back to the
compressor. Otherwise the com-
pressor could be damaged.
Electrical connection
Details on mains voltage, type of current and the fuses required should
be taken from the type plate. The type plate is fitted near the loading
aperture (see “Machine description” section).
Important:
The plug must be accessible after the appliance has been installed.