Filter
Top Products
30
Changing door stop
1
Warning! The door stop may only be changed by a specialist. If neces-
sary, please contact our after-sales service or your specialist dealer.
Warning! Before changing the door stop, disconnect the mains plug;
with a permanent connection: fully unscrew or deactivate the fuse.
1. Open loading door.
2. Unscrew hinge A from the front of
the machine and take off the load-
ing door.
3. Remove cover plates B and C. To do
this, insert a thin screwdriver into
the slots as shown in the illustra-
tion, press downwards slightly and
pry out the cover plates.
4. Use an appropriate tool and exert
pressure to unfasten locking block D
from the snap-on fixture, take out
and reinsert on the other side, hav-
ing rotated the block through 180°.
5. Unscrew hinge A from the loading
door, rotate through 180°, reinsert
on the opposite side and screw
down.
6. Reinsert cover plates B and C on the opposite site having first rotated
them through 180°.