AEG 16820 Washer/Dryer User Manual


 
54
Electrical connections
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this safety measure
not be observed.
If the plug that is fitted to your appliance is
not suitable for your socket outlet, it must be
cut off and the appropriate plug fitted.
Remove the fuse from the cut off plug.
The cut off plug should then be disposed of
to prevent the hazard of shocks in case it
should be plugged into a 13 Amp socket in
another part of your home.
Important
The wires in the mains lead are coloured in accordance with the fol-
lowing code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
If you fit your own plug, the colours of the wires in the mains lead of
your appliance may not correspond with the markings identifying the
terminals in your plug, proceed as follows:
Connect the green and yellow (earth) wire to the terminal in the plug
which is marked with the letter «E» or the earth symbol or coloured
green and yellow.
Connect the blue (neutral) wire to the terminal in the plug which is
marked with the letter «N» or coloured black.
Connect the brown (live) wire to the terminal in the plug which is
marked with the letter «L» or coloured red.
The plug moulded on to the lead incorporates a fuse. For replacement, use
a 13 Amp BS1363 fuse. Only ASTA or BSI approved fuses should be used.
The plug must not be used if the fuse cover/carrier is lost. The
cover/carrier is indicated by the coloured insert at the base of the plug.
A replacement cover/carrier must be obtained from your local AEG Service
Centre.
The power supply cable must be easily accessible after installing the
machine.
Installation
GREEN &
YELLOW
13AMP FUSE
CORD CLAMP
BLUE
13
AMP
BROWN
132988620.qxd 12/07/2004 16:07 Pagina 54 (Nero/Process Black pellicola)