Filter
Top Products
The upright standpipe should have a mini-
mum length of 30 cm (12”) from the bottom
of the elbow to the top of the pipe (see dia-
gram). Make sure that it is designed in such a
way that the end of the drain hose cannot be
covered with water.
If you intend the drain hose from the machine
to empty into a sink, make sure that the sink is
empty and the plug hole is not blocked. Use the
plastic “U -Piece” supplied.
Important
Before connecting up the machine to new
pipework or to pipework that has not been used
for some time, run off a reasonable amount of water to flush out any debris
that may have collected in the pipes.
In the interest of the environment
Washing machines and dish-
washers should be connected
to the FOUL drainage system,
the water will then be taken to
a sewage works for treatment
before being discharged safely
into a river.
It is essential that these appli-
ances are not connected to the
surface water drainage system
as this water is discharged
directly into a river or stream
and may cause pollution.
If you require any further advice
please contact your local water
authority.
Installation
SHOWER
BATH
SINK
TOILET
BIDET
WASHING
MACHINE
DISHWASHER
RAINWATER
'RUN-OFF'
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER
FOUL DRAIN
FOUL SEWERS
SEWAGE
TREATMENT
WORKS
RIVER
TREATED
DISCHARGE
RAINWATER
'RUN-OFF'
SURFACE WATER
DRAINS & SEWERS
Min. 30 cm.(12")
38 mm.(1/ ") diameter
standpipe
1
2
132988620.qxd 12/07/2004 16:07 Pagina 53 (Nero/Process Black pellicola)