Filter
Top Products
Water inlet (cold water connection only)
Connect the hose to a tap with a 3/4” thread.
Installation should comply with local water authority and building
regulations’ requirements.
The inlet hose is provided with a water
stop device, which protects against dam-
age caused by water leaks in the hose
which could develop due to natural ageing
of the hose. This fault is shown by a red
sector in the window “A”. Should this occur,
turn the water tap off and refer to your
Service Force Centre to replace the hose.
Set the hose correctly by loosening the ring nut. After positioning the
inlet hose, be sure to tighten the ring nut again to prevent leaks.
Do not connect to a hot water supply.
Water drainage
The appliance drain hose should hook into
a standpipe, the hook in the drain hose is
formed using the plastic “U-Piece” sup-
plied. The standpipe should have an inter-
nal diameter of approximately 38 mm (see
diagram on page 52) thus ensuring there is
an air break between the drain hose and
standpipe.
When discharging into a standpipe ensure
that the top of the curve in the hose end
is no more than 90 cm (35.4”)
and no less than 60 cm (23.6”)
above floor level.
52
Installation
A
3 pin
Max. 90 cm.(35.4")
Min.60 cm.(23.6")
132988620.qxd 12/07/2004 16:07 Pagina 52 (Nero/Process Black pellicola)