Using Dynamic Job Descriptor Entries (DJDEs)
Using LCDS Print Description Language 5-73
• When simplex mode is put into effect, as is done by use of
the TRANS DJDE, the system ensures that the first simplex
page printed after the DJDE is on an odd numbered page. To
accomplish this, the system forces a blank back side for the
last duplex page.
However, if you specify TRANS=NO and DUPLEX=YES, the
system ensures that the first duplex page is printed on an
odd numbered page.
XMP DJDE
(Xerographic Mode Persistence) Controls the xerographic mode
switching between black and color printing for a report.
Type Record oriented
Syntax XMP = {DEFAULT | REPORT}
Options
XSHIFT DJDE
Specifies whether the image of the form and data on a page is to
be shifted, and if so, by what values. This DJDE shifts the data
downward (in the x direction) for short edge binding, because a
long edge feed page is viewed in portrait mode. It is typically
used to accommodate top drilled paper, binding, finishing, and
edgemarking.
Type Page oriented
Syntax XSHIFT = {YES | NO | (v
1
, v
2
)}
Table 5-63. XMP DJDE options and definitions
Option Definition
DEFAULT Specifies that the xerographic mode switching that was specified at installation
will be used for the report.
REPORT Specifies that when the system determines that a report requires highlight color
for a page, all subsequent pages of the report will print in highlight color.
