Printer requirements and specifications
6-6 Installation Planning Guide
Space requirements
You should consider the following factors when deciding where to
place the printer hardware components:
• Adequate work space and service clearance around the
equipment
• Proximity to electrical and network connectors
• Security of the work area. You may need to place the system
in an area where you can restrict access to it. This may be
important if your personnel need to print confidential
documents or if you are concerned with unauthorized usage.
Dimensions and weights of the printer components are listed in
this section, along with diagrams, to help you visualize the sizes
and total space requirements.
NOTE: There must be a 78 inch / 198 cm vertical clearance
throughout the entire area. In addition, your printer must be
installed in a fixed location with a minimum clearance space of
36 inches / 91.4 cm around all sides of each piece of equipment
for access by service personnel. In addition, there must be 50
inches / 126.9 cm clearance space in front of the printer.
For information on clearance space and other space planning
considerations, refer to the “Space planning guidelines” section
of this chapter. Contact your service representative if you have
questions not specifically addressed in this guide.
Printer configurations available
The following configurations are available for the printer:
• Printer + inverter feeder/stacker + 1 feeder/stacker
• Printer + inverter feeder/stacker + 2 feeder/stackers
• Printer + inverter feeder/stacker + 3 feeder/stackers.
Measurements and a top-view diagram for each of these
configurations is provided on the following pages.
