Printer components and options
3-6 Installation Planning Guide
Bypass transport
printer
configurations
The following printer configurations may have the bypass
transport, illustrated below:
• Printer with inverter feeder/stacker and 1 feeder/stacker
• Printer with inverter feeder/stacker and 2 feeder/stackers
Figure 3-6. Printer with inverter feeder/stacker,
one feeder/stacker, and bypass transport
Figure 3-7. Printer with inverter feeder/stacker,
two feeder/stackers, and bypass transport
Roll feeder support (DP155 and DP180 EPS only)
The roll feeder option may be installed in the inverter feeder/
stacker module, replacing the feeder tray. This option does not
require DFA or input enablement software, or any additional
hardware.
The maximum number of feeder/stacker modules supported for
this configuration is four, including the inverter module with the
roll feeder. With the two processor feeder trays, this makes a
total of six input trays possible.
