Installation
Step 9: Configure Stratagy Admin Software
18 Stratagy IVP8 Installation Guide 01/02
Step 9: Configure Stratagy Admin Software
Settings for the communication port in Stratagy Admin must match the corresponding parameters
set in the Stratagy System Configuration file on the Stratagy IVP8.
For example, the Stratagy Admin PC serial port settings made in the
Serial Port field of this
procedure must be identical to the serial port definitions (i.e.,
set serial_port) set in the
Stratagy IVP8’s System Configuration file (see “Stratagy System Configuration” on page 24).
Note The menu screens detailed in this section are only available with Stratagy Admin version
VSA.2G or later.
➤ To configure Stratagy Admin software
1. From the
C:\ADMIN3 DOS prompt, type admin and press Enter. The Stratagy Admin
screen displays.
2. From the Stratagy Admin
Main screen, press
2 or
highlight the Configure
Admin option and press
Enter. The Admin PC
Configuration screen
displays (shown right).
Note Press F1 for help with
any settings in the
Stratagy Admin Configuration screen.
3. Make any changes needed. See Table 2 on page 19 for a description of each of the fields.
Note Press F2 in the Serial Port and Baud Rate fields to display a pop-up box with valid entries.
4. To save your changes, you must have the cursor in the last field (i.e., Modem Init String), and
press
Enter or the arrow down (↓) key
...or to exit without saving your changes, press
Esc at any time.
The program returns to the Stratagy Admin Main screen.
3230
