10.
11.
12.
13.
14.
15.
16.
When making duplex prints, misdetection of paper wrapping may occur
because the paper delivery sensor detects the black area at the leading
edge of the back side. Keep more than 10mm/O.4° blank area at the
leading edge of the back side of the printing paper.
Do not use the thermal head cleaner for anything but cleaning the ther-
mal head.
Also, be Sure to read ttle cautions about the thermal head
cleaner, and be careful as this cleaner is an alcohol.
Take note of the following regarding the cleaner:
●
●
●
●
●
●
Do not take internally.
Do not breathe it.
Keep out of the reach of children.
If it comes in contact with skin, wash well with water.
Keep away from eyes. If it comes in contact with your eyes, wash well. If
irritation occurs, contact
your doctor.
Never place it whet’e it will be exposed to heat.
When feeding 51/2’’x8l/2° paper in the sideways direction, the prints may
not stack correctly on the paper delivery table. In this case, push up the
wing guide release lever.
Perform a test print using the Proof key as the first few prints may be
light.
When the machine
is m and the power source is less than 90% of the
specified amount, printing quality will decrease. Therefore, make sure
the mains supply is at
least 90% of the required amount.
Such paper as postcards
do not absorb ink well. Therefore, offset im-
ages may appear on the rear side of following prints.
Solid
image
originals will make offset image prints.
AS various kinds and qualities of paper
exist, Some paper may be
wrapped around the drum and/or cause jams.
55
