A SERVICE OF

logo

Open as PDF
next previous
3. Master Roll Replacement
I
1. Open the original table.
●
Lift the original table release lever and
slide the original table to the “ Y “ mark.
2. Lift the pressure release lever in the
direction of the arrow to release the
feed roller pressure.
3. Remove the used master roll and pull
out both spools. Thenj insert both
spools into a new master roll (Type
VT-s).
. When the Master End indicator lights, it is
necessary to replace the master roll even
if some paper remains on the old roll.
4. The new master roll must be posi-
tioned as shown in the illustration.
38