Monitoring and Configuring the Printer
92
4
diprint
The direct printing port enables direct
printing from a network-connected
computer.
Use the “diprint” command to change
direct printing port settings.
❖
❖❖
❖ View settings
The following command displays
the current direct printing port set-
tings:
msh> diprint
Example output:
port 9100
timeout=300(sec)
bidirect on
• The “port” specifies the port
number of the direct printing
port.
• The “bidirect” setting indicates
whether the direct printing port
is bidirectional or not.
❖
❖❖
❖ Setting timeout
msh> diprint timeout {30–
65535}
• You can specify the timeout in-
terval to use when the printer is
expecting data from the net-
work.
• The default is 300 seconds.
❖
❖❖
❖ Setting bidirect
msh> diprint bidirect { on
| off }
• You can specify whether the di-
rect printing port is bidirection-
al or not.
dns
Use the “dns” command to configure
or display DNS (Domain Name Sys-
tem) settings.
❖
❖❖
❖ View settings
The following command displays
current DNS settings:
msh> dns
❖
❖❖
❖ DNS server configuration
The following command enables or
disables the DNS server address:
msh> dns “number” server
“server address”
The following command displays
a configuration using the IP ad-
dress 192.168.15.16 on a DNS 1
server:
msh> dns 1 server 192.168.
15.16
• You can register up to three
DNS server numbers.
• You cannot use “255.255.255.255”
as the DNS server address.
❖
❖❖
❖ Dynamic DNS function setting
msh> dns “interface_name”
ddns {on|off}
• You can set the dynamic DNS
function "active" or "inactive".
• {on} means "active" and {off}
means "inactive".
• ip1394 can be specified only
when the IEEE 1394 interface is
installed.
• wlan can be specified only
when the IEEE 802.11b interface
is installed.
Interface name
Interface configured
ether Ethernet interface
ip1394 IEEE 1394 interface
wlan
IEEE 802.11b interface
