A SERVICE OF

logo

9
Using the gasket as a template mark the center hole and 3 fixing holes.
Use a 9/16” drill bit to drill the center hole and a 7/64” drill bit to make
pilot holes for the fixing screws.
Fix the mounting gasket and flange into position using the supplied screws.
Thread the cable and connector through the mounting flange and gasket.
Attach the antenna to the mounting flange, making sure the ‘O’ ring is in
position.
D9071_1
Step 1
D9072_1
Step 2
D9073_1
Step 3
'O' ring
Step 4
D9074_1
87067_1.book Page 9 Wednesday, February 22, 2006 7:44 AM