Chapter 3
3-20
Power Management
This item is used to select the degree (or type) of power saving and is related
to these modes: Suspend Mode and HDD Power Down. There are three op-
tions for power management:
Min Saving Minimum Power Management. Suspend Mode = 1 Hour.
Max Saving Maximum Power Management. Suspend Mode = 1 Min.
User Define Allows end users to configure each mode separately.
Suspend Mode
If system activity is not detected for the length of time specified in this field, all
devices except CPU will be shut off. Settings are Disabled, 1 Min, 2 Min, 4
Min, 8 Min, 12 Min, 20 Min, 30 Min, 40 Min and 1 Hour.
Modem Use IRQ
This setting names the interrupt request (IRQ) line assigned to the modem (if
any) on your system. Activity of the selected IRQ always awakens the system.
Setting options: 3, 4, 5, 7, 9, 10, 11, AUTO.
Hot Key Function As
This setting specifies the function of the preset hot key (Ctrl+Alt+Backspace).
Setting options: Disable, Power Off, Suspend. (This feature is applicable only
if it is running under the DOS OS.)
HDD Off After
When enabled and after the set time of system inactivity, the hard disk drive
will be powered down while all other devices remain active. The settings are:
Disable, 1~15 Min.
Power Button Function
This item sets the function of the power button. Available settings are:
Power Off The power button is normal power on/off function
key.
Suspend When you press the power button, the computer
enters the suspend/sleep mode, but if the button is
pressed for more than four seconds, the computer is
turned off.
