Fig. 8
(A) 13/16in (20mm) (C) 1-3/16in. x 3/8in.
( 30mm x 10mm )
(B) 3-15/16in (100mm) (D) min. 4in (100mm)
u
Maintain the dimensions shown in
Fig. 8
so that the filter
can be replaced and the cover can be removed.
u
The tape on the water filter is not needed and can be cut
off.
4.4 Cabinet door setup
Fig. 9
The cabinet must have a door.
This door is generally constructed as follows:
-
The door must be at least 5/8 in. (16 mm) and at most
3/4 in. (19 mm) thick so that the connecting rails can be
fixed on it.
-
There must be a gap
Fig. 9 (1)
at least 1/8 in. (3 mm) wide
between the door and the cabinet door above it (if
present).
-
The width of the cabinet doors depends on the kitchen
style and size of the gaps between the door panels of the
cabinetry. Generally, a 1/8 in. (3 mm) vertical gap
between the cabinet doors is recommended.
-
The upper edge of the door
Fig. 9 (2)
should be level with
the door of the adjacent cabinet (or cabinets), if other
cabinets are present.
-
Align the door before installing the appliance. Once you
have installed the appliance, you can no longer correct
the door position.
u
Check the fitting dimensions according to the
specifications in
Fig. 7
.
Kitchen cabinet setup
7
