q
the air flow is not restricted. Air flow must be provided for
the appliance to operate properly. The factory air vents
provide 31 square inches (200 cm
2
) of air flow per
appliance. If you are replacing the air vents with an
overlay, the air flow must be the same or greater than the
factory air vents.
u
Examine the unit and packaging for shipping damage.
Contact the carrier immediately if you suspect there is
any damage.
u
Note the type (model, number), index, appliance/serial
number, date of purchase and where purchased .
u
Remove anything attached to the rear or side walls of
appliance that would prevent proper installation or
impede proper ventilation.
If the appliance is set up in humid areas, condensation may
build on the outside of the appliance.
u
Always ensure proper ventilation.
3 Reversing the door
Make sure you have the following tools on hand:
q
Phillips screwdriver
q
Slot screwdriver
q
•
Cordless screwdriver Torx 15
•
Cordless screwdriver Torx 20
•
Cordless screwdriver Torx 25
Disconnect the power plug.
Open the door.
3.1 Detaching the soft stop
mechanism
Fig. 1
CAUTION
Risk of injury if soft stop contracts!
u
Detach with care.
u
Use a screwdriver to slide the tension spring
Fig. 1 (11)
outwards.
u
Remove the soft stop mechanism
Fig. 1 (2)
by pulling it
downwards.
u
Unscrew the retainer
Fig. 1 (1)
.
u
Unscrew the ball stud
Fig. 1 (3)
using an open-ended
wrench.
3.2 To remove the door
Fig. 2
u
Remove the covers
Fig. 2 (4)
.
u
Just loosen the fixing screws
Fig. 2 (5)
.
u
Remove door: Push outwards, unhook and put to one
side.
3.3 Swapping bearing parts
CAUTION
Hinges are spring-loaded and can cause pinching injuries!
u
Leave hinges open.
u
Swap the fixing screws
Fig. 2 (5)
on the top and
bottom to the opposite
side.
The screws are self-tapping.
Use a cordless screwdriver:
u
Unscrew
Fig. 3 (9)
the
hinges from the door and
swap them over.
u
Close off the now unused
holes with plugs
Fig. 3 (10)
.
Fig. 3
3.4 Installing the door again
u
Hang the appliance door on the pre-fitted fixing screws
Fig. 2 (5)
.
u
Tighten the fixing screws
Fig. 2 (5)
.
u
Re-attach the covers
Fig. 2 (4)
.
Reversing the door
3
