5: Commands and Levels
Applies tunnel protocol on the line.
Asserts line status with current configured values.
Displays the current status.
Shows the command mode settings for the current line.
Displays the last 20 commands entered during the current
CLI session.
Displays the current configuration.
Shows the line statistics.
Disables the line so data cannot be sent/received.
Enables the line so data can be sent/received.
Uses one stop bit after data on the line.
Uses two stop bits after data on the line.
Enters the configure-terminal level.
<line> = number of the terminal line (serial port) to be
Enters the configure-terminal level for the network.
Refrains from terminating the line.
Enables 120 ohm line termination in RS485 half-duplex
mode.
Sets the threshold in bytes. After this many bytes are re-
ceived, they are
<line> = number of the tunnel line (serial port) to be con-
Stores the current configuration in permanent memory.
Sets the xoff character for use with software flow control
on this line.
The character may be input as text, control, decimal, or
hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
Sets the xon character for use with software flow control
on this line.
The character may be input as text, control, decimal, or
hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
link (config-ethernet:eth0) level commands
Restores the default duplex setting, which is auto.
Restores the default speed setting, which is auto-
negotiate.
Sets duplex mode to auto.
Sets duplex mode to full.
Sets duplex mode to half.
Exit back to interface configuration level
Displays the current configuration.
XPort® Pro Lx6 Embedded Device Server Command Reference 79
