A SERVICE OF

logo

Tower-to-rack conversion 45
Figure 4. Rotating the front feet
b. Carefully use a flat-blade screwdriver to push in the tabs on each of the four
feet and remove them from the system. Store the feet for possible future use.
Figure 5. Removing the system feet
9. Move the power-switch and LED panel to the rack-orientation location.
a. If the system has hot-swap drives installed, note their locations; then, remove
them (see “Installing a hot-swap hard disk drive in bay 5, 6, or 7” on page 72)
and place them in a safe place.
b. Rotate the drive cage upward, so that you can reach through to the other side
of the power-switch and LED panel cable.