A SERVICE OF

logo

Open as PDF
next previous
8.
Remove
the
air
baffle
for
the
microprocessors
by
pulling
it
outward
and
lifting
it
out
of
the
computer.
DIMMs
Heat sink
release lever
Heat sink 2
Microprocessor 2
Microprocessor
baffle assembly
Microprocessor
air baffle
VRM for second
microprocessor
9.
Locate
the
second
microprocessor
socket
(Microprocessor
2)
on
the
system
board.
10.
Remove
the
microprocessor
baffle
assembly
from
the
second
microprocessor
socket.
a.
Press
down
on
the
blue
touch
point
of
the
heat-sink
release
lever
and
rotate
the
lever
all
the
way
out
until
it
stops.
b.
Grasp
the
front
of
the
microprocessor
baffle
assembly
and
tilt
it
up
while
pulling
the
rear
flange
out
of
the
heat-sink
retention
module;
then,
lift
it
out
of
the
computer
and
stoe
it
in
a
safe
place.
11.
If
the
second
microprocessor
socket
is
covered
with
protective
film
or
a
label,
peel
and
remove
the
film
or
label.
12.
Install
the
microprocessor:
a.
Touch
the
static-protective
package
containing
the
new
microprocessor
to
any
unpainted
metal
surface
on
the
computer;
then,
remove
the
microprocessor
from
the
package.
b.
Rotate
the
locking
lever
on
the
microprocessor
socket
from
its
closed
and
locked
position
until
it
stops
or
clicks
in
the
fully
open
position
(approximately
135°).
Attention:
You
must
ensure
that
the
locking
lever
on
the
microprocessor
socket
is
in
the
fully
open
position
before
you
insert
the
microprocessor
in
the
socket.
Failure
to
do
so
might
result
in
permanent
damage
to
the
microprocessor,
microprocessor
socket,
and
system
board.
c.
Position
the
microprocessor
over
the
microprocessor
socket.
Align
the
triangle
on
the
corner
of
the
microprocessor
with
the
triangle
on
the
corner
of
the
socket
and
carefully
press
the
microprocessor
into
the
socket.
Chapter
2.
Installing
the
hardware
37