1-2
1.2 Turning On and Off the
Power
Turning on the power
Press the [DIM/PWR] key. The unit beeps
and then starts up with the last-used dis-
play mode.
Your equipment takes about two minutes
to find its position when turned on for the
very first time.
The equipment shows receiver status indi-
cations at the top left-hand corner in all dis-
play modes. Table 1-1 shows these
indications and their meanings.
Table 1-1 Receiver status indications
noitacidnIgninaeM
D2xifnoitisopSPGD2lamroN
POD
PODhtiwxifnoitisopSPG
ro)xifnoitisopD2(4nahterom
)xifnoitisopD3(6
D3xifnoitisopSPGD3lamroN
D2D
SPGlaitnereffidlamroN
xifnoitisop
D3D
SPGlaitnereffidD3lamroN
xifnoitisop
MIS.edomnoitalumiS
:POD rofxedniehT.noisicerPfonoituliD
ehtrehgihehT.ycaruccagnixif-noitisop
ehtfoycaruccaehtrehgihehtrebmun
.xifnoitisop
:etoN nosdnepedoslaycaruccanoitisoP
.noitisopetilletas
Turning off the power
Press and hold down the [DIM/PWR] key
until the screen goes blank, approx. three
seconds. The time remaining until power
off is counted down on the display.
1.3 Adjusting Display Dimmer
and Contrast
1. Press the [DIM/PWR] key with a touch-
and-release action. The display shown
in Figure 1-2 appears.
DIMMER (1~8)
CONTRAST (0~63)
s
t
▲
▼
4
41
EXIT:[ENT]
Figure 1-2 Screen for adjustment of
display dimmer and contrast
2. To adjust the dimmer, press ▲ or ▼. Cur-
rent setting is shown to the right of “▲”.
3. To adjust the contrast, press t or s.
Current setting is shown to the right of
“s”.
4. Press the [ENT] key to finish.
Note: If you turn off the power with
minimum contrast,nothing appears on the
display when you turn on the power
again.Adjust the contrast as described
above.
