6. WEB FUNCTIONS
6-44
5. Click the [Disconnect] button to disconnect the data connection. Closing the ap-
plication does not disconnect the line.
How to show the PPPoE status monitor display
The PPPoE status monitor display shows the packet communication volume for the
current PPPoE session.
1. Start the Internet Explorer
®
and connect to the internet with PPPoE as shown in
the procedure on page 6-42.
2. Enter http://192.168.254.1 in the address bar then press the [Enter] key to show
the PPPoE status monitor display.
6.1.7 How to change the password
Do the following procedure to change the SMS password, log password, and Admin-
istrator password. Write down the password in log so as not to forget the password. If
the password is lost, contact the dealer or retail supplier.
1. Click [Settings] in the menu bar.
2. Click [Password]. The following password setting screen appears.
3. Enter the new password in the [New password] field.
Solid black circles appears as characters. The number of characters is limited as
follows:
• SMS password: Max. 8 characters
• Log, Administrator password: 4-8 characters
4. Enter the new password again in the [Confirmation] field.
5. Click the [Apply] button. The message "Setting Completed" appears.
Note: The message "New Password isn’t corresponding" appears when the pass-
word entered in the [New password] field does not match that entered in the [Con-
firmation] fields.
6. Click the [OK] button.
