MO270-EU-EN v2.3 5/14
10
Measurement Screen Menus
F1 - MENU
Press the F1 MENU button from the main analyzer display to open the sub-menu list:
WME/REL
The WME/REL menu allows for selecting either pin measurements, displayed as a ‘wood
moisture equivalent %’ (WME), or pin-less measurements displayed as a relative measurement
(REL) using the non-contact sensor. When highlighted, use the ENTER button to toggle
WME and REL.
ALARM
1. Navigate to the ALARMS box and press the button.
2. Alarm limits can be set manually by entering a numerical value or by using a measurement
(scanned) value.
3. To set an Alarm limit manually, use the right arrow to scroll to the Alarm limit (%) box and
press . An arrow will appear under one of the digits, use the up and down arrow buttons
to change its value if desired. Use the left and right
arrows to choose another digit to edit. When finished
editing, press the button store the setting.
4. To use the real time measurement as the alarm limit,
use the arrow keys to scroll over to the SCAN box (for
either the HIGH or the LOW Alarm limit). When the
SCAN box is highlighted, press the button to
automatically transpose the real time measurement to
the Alarm limit value. Important: Press the CONF key to the lock the reading in place.
5. Note that the High Alarm limit cannot be set lower than the Low Alarm limit and the Low
Alarm Limit cannot be set higher than the High Alarm limit.
6. To turn an Alarm ON or OFF: Use the arrow buttons to move the cursor to the Alarm limit
OFF box. Press the button to toggle between ON (OFF) or OFF (OFF).
7. To set the audible Alarm beeper ON or OFF: Navigate to the SOUND ON or OFF box.
Select the desired condition and the press .
8. Press F3 to store the values and to exit this mode.
9. Refer to Alarm Operation instructions later in this instruction manual.
MEMORY
The MEMORY menu allows for viewing data and naming/clearing data for up to 10 memory
groups with 9 memory locations each. Refer to the dedicated ‘Memory Logging Mode’ section
later in this guide.
MENU
MODE
F1 F3F2
MENU
BACK EXIT
WOOD TYPE
MEMORY
WME/REL
ZERO MODE
ALARM
BACK
CONF
EXIT
HIGH
SCAN
OFF
LOW
SOUND
SCAN
OFF
ON
OFF
26.5
87.2
%
%
ALARMS
