32 ELS100-24TXM User Interface ELS100-24TXM
Switch Configuration Menu
The Switch Configuration Menu allows you to modify switching-related
configuration parameters. Select
b
from the Main Menu to view the Switch
Configuration Menu. Figure 3-6 shows the Switch Configuration Menu
and the accompanying table describes the Switch Configuration Menu.
Figure 3-6. Switch Configuration Menu
SWITCH CONFIGURATION Access Control: READ/WRITE
a. Forwarding Table Configuration Menu
b. Spanning Tree Configuration Menu
c. VLAN Configuration Menu
d. Class of Service Configuration Menu
e. Forwarding Table Aging Time(seconds) 300
f. Broadcast Cutoff Rate 500000
g. Port Mirroring Enable No
h. Mirrored Port 2
i. Mirroring Port 1
j. Transmit Data Mirror Enable Yes
k. Receive Data Mirror Enable No
x. Previous Menu
Enter Selection:
Selection Description
Forwardin
Table
Confi
uration Menu
Menu for confi
urin
the switch forwardin
table.
Spannin
Tree Confi
uration
Menu
Menu for confi
urin
the switch Spannin
Tree
operation.
VLAN Confi
uration Menu Menu for confi
urin
the VLAN operation of the switch.
Class of Service Confi
uration
Menu
Menu for confi
urin
Class of Service for the switch.
Forwardin
Table A
in
Time Time in seconds until entries in the filter table are a
ed
out if not accessed (10-1,000,000 second ran
e).
Broadcast Cutoff Rate Per second rate past which broadcast and destination
unknown unicast frames are not flooded on each
roup of 8 ports on the switch (100-500,000 frames per
second ran
e).
Port Mirrorin
Enable Allows you to enable (Yes) or disable (No) port mirror-
in
.
Mirrored Port The source port for the data to be mirrored.
Mirrorin
Port The destination port for the data to be mirrored.
Transmit Data Mirror Enable * Allows you to enable (Yes) or disable (No) the mirror-
in
of data transmitted out the mirrored port.
Receive Data Mirror Enable * Allows you to enable (Yes) or disable (No) the mirror-
in
of data received by the mirrored port.
* Only one of these options can be enabled at any given time. Changing the setting
of one of these options automatically changes the setting of the other option.
