set timezone 157
■ “display summertime” on page 129
■ “display timedate” on page 130
■ “display timezone” on page 131
■ “set summertime” on page 153
■ “set timezone” on page 157
set timezone Sets the number of hours, and optionally the number of minutes, that the
wireless LAN switch’s real-time clock is offset from Coordinated Universal
Time (UTC). These values are also used by Network Time Protocol (NTP), if
it is enabled.
Syntax —
set timezone zone-name {-hours [minutes]}
■ zone-name — Time zone name of up to 32 alphabetic characters. You
can use a standard name or any name you like.
■ - (minus sign) — Minus time to indicate hours (and minutes) to be
subtracted from UTC. Otherwise, hours and minutes are added by
default.
■ hours — Number of hours to add or subtract from UTC.
■ minutes — Number of minutes to add or subtract from UTC.
Default — If this command is not used, then the default time zone is
UTC.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — To set the time zone for Pacific Standard Time (PST), type
the following command:
WX1200# set timezone PST -8
Timezone is set to 'PST', offset from UTC is -8:0 hours.
See Also
■ “clear summertime” on page 115
■ “clear timezone” on page 116
■ “display summertime” on page 129
■ “display timedate” on page 130
