Filter
Top Products
Problems Causes
Wash is unsatisfactory : • the detergent is unsuitable for machine washing,
• there is too much washing in the drum,
• the wash cycle is unsuitable,
• there isn’t enough detergent.
The appliance vibrates, is
noisy :
• all packaging have not been removed from the appliance (see installation section),
• the appliance isn’t level and is unbalanced,
• the appliance is too close to the wall or furniture,
• washing is unevenly distributed in the drum,
• the load is too small.
The wash cycle is much too
long :
• the water inlet filters are dirty,
• the power or water supply has been cut off,
• the motor overheating detector has been activated,
• the water inlet temperature is lower than usual,
• the foam detection security system has been activated (too much detergent) and the
washing machine has begun draining the foam,
• the out of balance detector has been activated: an extra phase has been added to
distribute washing more evenly in the drum.
The washing machine stops
during a wash cycle :
• the water or electricity supply is defective,
• a Rinse hold has been selected,
• the drum shutters are open.
The lid doesn’t open at the
end of the cycle :
• the temperature inside the drum is too high,
• the lid unlocks 1 - 2 minutes after the end of the cycle.
The E40 error code appears
in the display
2)
and the
“Start/Pause” pushbutton
flashes red
3)
:
• the lid is not closed properly.
The E20 error code appears
in the display
2)
and the “Start/
Pause” pushbutton flashes
red
3)
:
• the drainage filter is obstructed,
• the drain hose is blocked or bent,
• the drain hose is fixed to high (see "Installation" section),
• the drainage pump is blocked,
• the standpipes blocked.
The E10 error code appears
in the display
2)
and the
“Start/Pause” pushbutton
flashes red
3)
:
• the water tap is closed,
• the water supply has been cut off.
•
a red tab appears on the water inlet hose
1)
.
8
www.zanussi.com