Filter
Top Products
Untying
AB
C
D
A
1
2
B
2
1
2
1
1
C
D
To install your washing machine at the same level as sur-
rounding furniture, proceed as shown on picture D.
Water supply
Install the supplied water inlet hose at the rear of your
washing machine by proceeding as follows. Do not reuse
an old hose. The water inlet hose can not be extended. If it
is too short, please contact the after-sales service.
90
O
90
O
90
O
Open the water inlet tap. Check there are no leaks.
Drainage
Fit the U-piece on the drain-
age hose. Place everything
in a drainage point (or in a
sink) at a height of between
70 and 100 cm. Ensure it is
positioned securely. Air
must be able to enter the end
of the hose, to avoid any risk
of siphoning.
The drain hose must never be stretched. If it is too short,
contact an engineer.
Electrical connection
This washing machine must only be connected in single-
phased 220-230 V. Check the fuse size: 13 A for 220-230
V. The appliance must not be connected with an extension
lead or multi-plug adaptor. Ensure that the plug is earthed
and that it is in accordance with current regulations.
Positioning
Position the appliance on a flat and hard surface in a ven-
tilated location. Ensure the appliance does not come into
contact with the wall or other furniture. Accurate levelling
avoids vibrations, noise and prevents the appliance from
moving when running.
max
100 cm
min
70 cm
Environment
Disposing of the appliance
All materials carrying the symbol are recyclable.
Dispose of them at a waste collection site (enquire
at your local council) for collection and recycling. When
disposing of your appliance, remove all parts which could
be dangerous to others: cut off the power supply cable at
the base of the appliance.
The symbol
on the product or on its packaging indi-
cates that this product may not be treated as household
waste. Instead it should be taken to the appropriate collec-
tion point for the recycling of electrical and electronic
10
www.zanussi.com