Filter
Top Products
Programme
Maximum and Minimum Temperature
Cycle Description
Maximum Spin Speed
Maximum Fabrics Load
Type of Laundry
Options
Detergent
Compartment
O = OFF
For cancelling the programme which is running or to switch the machine off .
1) If you select the Super Quick option by pressing button 3, we recommend that you reduce the maximum load as indicated. Full
loading is possible however with somewhat reduced cleaning results.
2) If using liquid detergents, a programme without PREWASH must be selected.
What to do if…
Certain problems are due to lack of simple maintenance or
oversights, which can be solved easily without calling out
an engineer. Before contacting your local Service Centre,
please carry out the checks listed below.
During machine operation it is possible that the red pilot
light of button 5 blinks to indicate that the machine is not
working.
It is possible to recognize the fault machine by the number
of button 5 light flashes. If the number of flashes is differ-
ent from the ones indicated below, this is related to a fault
that you can not solve. In this case, contact your local
Service Centre.
Press simultaneously the buttons 4 and 5 for a few sec-
onds. The red button 5 light will flash for a short time as
described (the green flash is not to be considered) :
• 4 flashes = «The washing machine does not start», fol-
low the corresponding suggestions in «Possible
cause/Solutions» box and restart the programme.
• 1 flash = «The machine does not fill», follow the corre-
sponding suggestions in «Possible cause/Solutions»
box and restart the programme.
• 2 flashes = «The machine does not empty and/or does
not spin», follow the corresponding suggestions in
«Possible cause/Solutions» box and restart the pro-
gramme.
Once the problem has been eliminated, press the button 5
to restart the programme. If after all checks, the problem
persists, contact your local Service Centre.
Problem Possible cause/Solution
The washing machine does not start:
The door has not been closed (the button 5 red light blinks).
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The programme selector dial is not correctly positioned and/or the button 5
has not been pressed.
• Please turn the selector dial and/or press the button 5 again.
The delay start has been selected.
• If the laundry are to be washed immediately, cancel the delay start.
13