Filter
Top Products
Positioning and levelling
x 4
Level the appliance by raising or lowering the feet.
The appliance MUST be level and stable on a flat hard
floor. If necessary, check the setting with a spirit level.
Any necessary adjustment can be made with a spanner.
Accurate levelling prevents vibration, noise and dis-
placement of the appliance during operation.
Repeat the levelling action, if the appliance is not level
and stable.
Water inlet
Connect the hose to a tap
with a 3/4” thread.
35°
45°
Loosen the ring nut to angle the hose to the left or right
depending on the position of your water tap. Do not
place the inlet hose downwards. After positioning the
inlet hose, be sure to tighten the ring nut again to pre-
vent leaks.
Water drainage
Firstly form a hook in the end of the drain hose using
the plastic hose guide supplied with the appliance .
The end of the drain hose can be positioned in four
ways:
• Hooked over the edge of a sink using the plastic
hose guide.
Tie the plastic hose guide to the tap with a string to pre-
vent that the drain hose unhooks when the appliance is
emptying.
• Onto a sink outlet spigot.
8