Zanussi ZWH6121 P Washer User Manual


 
turn the program selector dial to “O”.
This option can be used for lightly soiled in order to obtain
a good washing result in a short time.
Quick Wash Buttons ( )
Rinse Hold ( ): by selecting this option the water of the
last rinse is not emptied out to prevent the fabrics from
creasing.
When the program has finished the pilot lights “End Cycle
( )” is on, the Start/Pause ( ) and the “Washing
( )” pilot light are off and the door is locked to indicate
that the water must be emptied out.
Auto Spin Reduction ( ): by selecting a programme,
reduce the spin speed if needed, by means of the
relevant button.
depress Start/Pause ( ) button.
at the end of program, only the pilot light End Cycle
( ) comes on.
select the Drain ( ) or Spin ( ) program.
To empty out the water:
The washing time will be reduced according to type of
fabric and the selected temperature.
13
Spin Buttons ( )
If an option is chosen that is not allowed with the selected
program, the red pilot light of the Start/Pause ( ) button
will flash 3 times.
set the washing machine to PAUSE by pressing the
Start/Pause ( ) button;
Before you start the program, if you wish to delay the
start, press the Delay Start button repeatedly, to select the
desired delay. The relevant light illuminates.
This option makes it possible to delay the starting of the
washing program by 3, 6, and 9 hours.
You must select this option after you have set the program
and before you press the Start/Pause button. You can
cancel the delay time at any moment, before you press the
Start/Pause button.
If you have already pressed the Start/Pause button, and you
wish to cancel the delay time, proceed as follows:
Select the Delay Start ( )
press the Delay Start ( ) button once, the light
relevant to the selected delay goes off.
press the Start/Pause ( ) button again to start the
programme.
the appliance proposes automatically the maximum spin
speed provided for that programme. By selecting Automatic
Spin reduction the spin speed is reduced to a half, but not
less than 400 rpm. The relevant light illuminates.