Filter
Top Products
32
Water inlet
An inlet hose is supplied and can been found
inside the machine drum.
Do not use the hose from your previous
machine to connect to the water supply.
1. Open the porthole and extract the inlet
hose.
2. Connect the hose with the angled
connection to the machine.
Do not place the inlet hose downwards.
Angle the hose to the left or right depending
on the position of your water tap.
3. Set the hose
correctly by loosening
the ring nut.
After positioning the
inlet hose, be sure to
tighten the ring nut
again to prevent leaks.
4. Connect the hose to a tap with a 3/4” thread.
Always use the hose supplied with the
appliance. The inlet hose must not be
lengthened. If it is too short and you do not
wish to move the tap, you will have to
purchase a new, longer hose specially
designed for this type of use.
45°
35°
NOTE
Installation should
comply with local
water authority and
building regulations’
requirements.
The appliance must be connected to a cold
water supply.
A minimum water pressure of 0.05 MPa (0.5
bar) is required for safe operation of the
appliance.
If you cannot make the cold water connection
direct from the rising mains, you may be able
to operate the appliance from your cold water
storage system.
There should be a minimum distance of 5.02m
(16.5 ft) between the appliance’s inlet and the
bottom of the water storage tank.
Water drainage
This appliance is designed to be permanently
plumbed into your home's drainage system
using one of the following methods.
1. Into a drainage standpipe.
30 cm (12")
38 mm (11.2)
standpipe
diameter
1
0
0
0
6
k
g
40°
30°Rinse
Delicates
ZWF10070W
Off
Special
95°Sport 40°
60° EcoSport Shoes 40°
60°
40° Eco
Silk
40°
50°
40°
Mini 30'
Hand
Wash
Cold
30°
Drain
Spin
Wool
Cottons
Synthetics
Easy Iron 40°
S
ta
r
t/
P
a
u
s
e
Wash
Door
End
E
x
t
ra
R
in
s
e
O
p
tio
n
s
S
p
in
1000
900
700
P
re
w
a
s
h
In
t
e
n
s
iv
e
S
u
p
e
r
Q
u
ic
k
3h
6h
9h
U piece
supplied
Installation instruction
Smart 132972560.qxd 18/06/2007 14.30 Pagina 32