Filter
Top Products
21
Operating sequence
Interrupting a programme
Depress the «Start/Pause» button to interrupt a
programme which is running, the
corresponding light starts to flash. Depress the
button again to restart the programme.
Cancelling a programme
Turn the selector dial to «Off» to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
«Start/Pause» button.
If the «Door Locked» icon desappears from
the display, the door can be opened.
If the «Door Locked» icon doesn’t
desappear, this means that the machine is
already heating, that the water level is above
the bottom edge of the door or that the drum is
turning.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «Off». After about 3
minutes the door can be opened
(pay attention to the water level and
temperature!).
After closing the door, it is necessary to selecte
the previously running programme again.
At the end of the programme
The machine stops automatically. Some
acoustic signals sound for few minutes. The
Start/Pause light goes off, the «Door Locked»
icon desappears and on the display will
appear a flashing «
0.00». The door can be
opened.
If the «Rinse hold» or «Night Cycle»
option has been selected, the display will show
a flashing «0.00» but the «Door Locked» icon
remains visible. The door is locked to
indicate that the water must be emptied out
before opening the door.
To empty out the water please read the steps
on the «Night Cycle» option paragraph.
Turn the programme selector dial to «Off» to
switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash,
close the water tap. Leave the door open to
prevent the formation of mildew and
unpleasant smells.
Smart 132972560.qxd 18/06/2007 14.30 Pagina 21