Filter
Top Products
20 electrolux something not working
Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer. Before contacting your local Service
Centre, please carry out the checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes to
indicate that the machine is not working.
Once the problem has been eliminated, press the button to restart the
programme. If after all checks, the problem persists, contact your local Service
Centre.
Malfunction Possible cause Solution
Dryer does not
work.
● Mains plug is not plugged in
or fuse is not working
correctly.
● Loading door is open.
● Have you pressed the START/
PAUSE button?
● Plug in at mains socket. Check fuse
in fuse box (domestic installation).
● Close loading door.
● Press the START/PAUSE button
again.
Drying results
unsatisfactory.
● Wrong programme selected.
● Lint filter clogged.
● Heat exchanger clogged with lint.
● Incorrect volume of laundry.
● Ventilation slots in base area
covered up.
●Residue on inside surface of
drum or drum ribs.
●Conductance of water at
installation site differs from
● Select a different programme the next
time you dry (see “Overview of
programmes” section).
● Clean lint filter.
● Clean heat exchanger.
● Observe recommended loading
volumes.
● Uncover ventilation slots in
base area.
● Clean inside surface of drum and
drum ribs
● Re-programme standard setting for
degree of drying
Loading door
does not close.
● Fine strainer not in place
and/or large mesh filter not
locked in place.
● Install fine strainer and/or
snap large mesh filter into
place.
125987350.qxp 2007-01-09 15:02 Page 20