Filter
Top Products
10 electrolux use
Press this button to start the dryer after
having selected the programme and
the options.
The relevant light will stop flashing.
If the programme selector dial is turned
to another position, when the machine is
running, the buzzer will sound and the
programme phase indicator lights will flash.
The drum turns alternately in both direc-
tions during drying.
All drying programmes end with a 10 minute
cooling phase (light Cooling is on).
You may remove the laundry after this
phase.
The lights End/Anticrease, Filter and
Empty Tank illuminate and the buzzer
sounds
In both cases the light of the Start/Pause
button flashes to remind you that the
start button needs to be pressed again.
Select the Delay Start
This button allows you to delay the starting of
the programme by 3, 6 or 9 hours.
Press the button until the light relevant
to the desired delay illuminates. This
option must be selected
after
having
selected the programme and
before
pressing START/PAUSE to start the
programme.
The machine begins the countdown,
which is shown by the pilot lights. For
example, if you have chosen a 9-hour
delay (pilot light 9h lit), after 3 hours, 9h
goes out and 6h lights up; after 3 more
hours, 6h goes out and 3h lights up.
When the 9 hours are over (pilot light 3h
off), the drying cycle begins.During the
delayed start period, it is not possible to
change the programme or the selected
delay. If you wish to do so, you must first
cancel everything by rotating the pro-
gramme selector dial to position “
Off
”.
Select the new programme, the options
and the delayed start, then press
START/PAUSE. If you wish to change
only the options, this can be done on the
condition that the new option(s) is(are)
compatible with the programme. Set the
machine to PAUSE by depressing the rel-
evant button, select the new option(s) and
depress START/PAUSE button again.
If you wish to add some laundry while the
machine is performing the countdown, after
having done so and having closed the door,
press START/PAUSE again, in order to allow
the machine to complete the remaining
countdown time.
Indicator lights
These lights indicate the following
functions:
“
Drying
”
light
This light indicates that the appliance is
in the drying phase
.
“Cooling” light
This light indicates that the appliance is in the
cooling phase. At the end of drying, there is
a 10 minute cooling phase to cool the
125987350.qxp 2007-01-09 15:02 Page 10
If the door of the appliance or the
smalldoor at the bottom is opened
while theprogramme is running, this
button mustbe pressed again after
closing the doorin order to restart the
programme fromthe point at which it
was interrupted.This button must be
depressed alsoafter a power failure
and after having re-inserted the water
reservoir, if it hasbeen emptied in the
middle of a pro-gramme after the
Empty Tank light illuminates.