Filter
Top Products
13
TROUBLESHOOTING
COMMON WASHING PROBLEMS (CONT.)
Solution...
•
This is normal.
•
This is normal.
•
Plug in power cord.
•
Turn Cycle Control knob to the
right slightly and pull to start.
•
Clean screens.
•
Turn on water.
•
Reverse hoses.
•
Straighten hoses.
•
Plug in power cord.
•
Check electrical source or call
electrician.
•
Replace fuse or reset circuit
breaker. If problem continues,
call electrician.
•
Do not use extension cords.
•
Turn knob to the right slightly
and pull to start.
•
Set and pull out knob.
•
Allow cycle to continue.
•
Wash smaller loads.
•
This is normal.
•
This is normal.
•
This is normal.
•
Push tub to center before
starting.
•
This is normal.
•
Ensure front feet are installed
and nuts tightened. Level
washer. Reset rear leveling legs.
See Installation Instructions.
Cause...
•
Gears engaging after drain and
before spin.
•
Upper part of agitator clicks during wash.
•
Power cord not plugged in.
•
Cycle Control knob is not lined up.
•
Water inlet valve screens are plugged.
•
Water is turned off.
•
Hot and cold hoses are reversed.
•
Inlet hoses are kinked.
•
Power cord not plugged in.
•
No power at plug.
•
Fuse blown or circuit breaker open.
•
Using an extension cord.
•
Cycle Control knob is not lined up.
•
Cycle Control knob not pulled out.
•
Washer at pause in Permanent Press
cycle (approximately 2 minutes).
•
Machine is overloaded.
•
The top of the agitator moves only in
one direction.
•
The top of the agitator is loose.
•
The top of the agitator is much higher
than the highest water level. This creates
a perception of the washer not being full.
•
Tub is pulled forward when unloading.
•
Tub moves.
•
Washer not level.
Problem...
Washer makes noise
(cont.)
Won’t fill/rinse/agitate
or wrong temperature
Washer stops
Agitator operation
Water level seems
too low or washer
not completely filling
Washer tub is crooked
continued on next page