Filter
Top Products
4-7
REMOVING THE THERMAL FUSE, THERMISTOR,
DRIVE MOTOR, & BELT SWITCH
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Open the dryer door and remove the lint
filter screen, then close the door.
5. Remove the hex-head screw from the lint
duct bracket and remove the bracket.
6. Remove the three hex-head screws from
the lint duct and remove the duct.
4. Remove the two hex-head screws from
the bottom flange of the toe panel. Pull the
panel out at the bottom, pull down, and
remove the panel.
Lint Filter Screen
Lint Duct Screws
Toe Panel
Toe Panel Screws
Continued on the next page.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Thermal Fuse
(2 Screws)
Thermistor
(2 Screws)
7. To remove the thermal fuse or ther-
mistor:
a) Remove the two wires from the termi-
nals.
b) Remove the two hex-head screws.
WARNING
Blower Cover