Filter
Top Products
2-6
1234567482 9 3457 2
3 6 296 76 34 576 3
Disconnect power.
Remove the hold-down screw and terminal block cover.
Install strain relief.
Remove the screws from a /" (1.9 cm) UL listed strain
relief (UL marking on strain relief). Put the tabs of the two
clamp sections into the hole below the terminal block
opening so that one tab is pointing up and the other is
pointing down, and hold in place. Tighten strain relief
screws just enough to hold the two clamp sections
together.
Put power supply cord through the strain relief. Be sure
that the wire insulation on the power supply cord is inside
the strain relief. The strain relief should have a tight fit with
the dryer cabinet and be in a horizontal position. Do not
further tighten strain relief screws at this point.
1234546
1234546