Filter
Top Products
Preparing to wash
Add measured detergent. Then place a sorted
load in the washer before starting. See page
12 for additional “Before you wash” informa-
tion.
Starting or stopping your washer
Starting your washer:
1.
Select a load size and water temperature.
2. Push in and turn the Cycle Control Knob
clockwise. Stop when the indicator on the
knob’s outer ring points to the number in the
wash cycle you want. The numbers are
minutes of wash time.
3. Pull out the Cycle Control Knob.
Refer to pages 6-9 for additional information to
help you make selections.
Stopping and restarting your washer:
l
To stop the washer at any time, push in the
Cycle Control Knob.
l
To restart the washer, close the lid (if neces-
sary) and pull out the Cycle Control Knob.
Selecting a load size
Position the Load Size Selector at the
setting that corresponds to the size load you
want to wash. Select a setting based upon
the size of the load and the fabric you are
washing. See page 12 for additional loading
information.
To change the load size setting after the washer
has started to fill, move the Selector to the
desired new setting.
Load size tips
l
Items should move freely during the wash. Do
not overload the machine or select a load size
that is too small for the wash load.
l
Use a large load size setting for best results
with permanent press clothes.
l
Reduce wash time when using a small load
size setting. Loads with only a few small
items need less wash time.
6