Whirlpool LSS8244A Washer User Manual


 
Operating Your Washer
In This Section
Pm
PWP
Bdom dwling your wahu
..............................
5 Saluting a cyck nd 6mo
................................. 7
About ttm 8pry-rirmo my&m ...........................
5 End of cyck signal
............................................. 7
Praparing to wash ..............................................
6
U&g sprmy rlnw and
l
pin
................................
9
Starting
or stopping your washer ....................
.6 Using drain nd spin
..........................................
6
Solacting
l
load l izo ..........................................
6
What happww in each cycle
.............................. 9
Safocting
wnh-rinw tunpu~tura .................
.7
Your Whirlpool washer has a revolutionary new spray rinse system. To obtain best washing
results, you must operate your washer properly. This section gives you this important information.
Before starting your washer
A water efficient, spray-rinse system replaces
the fill-agitation system used for rinsing in most
washers currently on the market. Therefore,
the spray-rinse system will be new to you.
Please read the following to understand how
clothes are rinsed in this revolutionary new
washer.
NOTE: If your washer has a Consumer
Features Guide, remove it and place it in your
Use and Care Guide.
About the spray-rinse system
The wash cycle ends with a drain and spin the
same as do many wash systems. Then your
new spray-rinse system takes over.
l
Your spray-rinse washer contlnws to spin
at the end of the wash cycle. There Is no fill.
l
Fresh water is added as the machine spins
the load. Repeated spinning with spray
rinses achieves excellent rinsing and uses
approximately 35% less water than other
washers of comparable size.
NOTES: To assure proper spray rinsing:
l
Do not open the lid during spray rinsing.
l
DO NOT USE liquid fabric softeners in this
washer. Use a dryer fabric softener instead.
Refer to pages 9 and 10 for more information
about what happens in each cycle.
b&J M
Spry riming
No fill
and spinning