Filter
Top Products
Removesorewo
A before opedng top
Drum se111 Bid0 panel
wire cllp-
hold. door
lfyourdrywbgasandhusafuUfront
pw~rsmovefKlntpenelasklbure:
1. Unplug the power supply cord or turn
off the electrical power.
2. Open lint screen lb. Remove two
screws in lint screen area.
3. Open top by pulling forward and up
at each front corner (see view A).
Rest raised top against wall behind
dryer (top is hinged at rear).
4. Remove two internal screws from
front panel flanges (near top front
comers). Lift front panel slightly.
liiing off bwer clips (see view B).
Sbwly pull front panel forward,
disengaging panel from drum. (Drum
will drop slightly.)
5. Move front panel aside and rest edge
against side of dryer. Avoid discon-
necting wire dips (see view C) or
damaging wires.
6. Remove lint from area shown in “gas
dryer illustration on page 11 with soft
brush or vacuum cleaner. Avoid
damaging wires, funnel or igniter.
7. Reassemble in reverse order. Before
dosing the top, chedr the following:
- Drum seal must be flared out (see
view D) and properly positioned
against panel at back of drum.
Rotate drum countercbckwise one
full turn to chech drum seal.
- Belt should he centered and tight
on dryer drum.
- Wire clips which hold the door
switch wires must be anchored in
sbt in top of front panel (see
view C) and along top edge of side
panel. Door wires must not touch
drum when dryer is operating.
Sse Warning, page 11.
6. Replace top panel and lint screen
screws. Top and front panels must
be securely in place before operating
dryer.
9. Reconnect power and level dryer
again (if necessary).
NOTE: Call Consumer Assistance at
1-600-263-l 301 for assistance or
more information.