Filter
Top Products
Proper and improper selections
The washer is designed to help you1 choose selections for the
best washing results. -
1.
For fabric protection, the washer
will not accept certain selections.
For example:
If you touch
then touch WARM
PERM’T. PRESS, RINSE, the warm
2.
rinse will not
be accepted.
The indicator lights will not Stay
on and 3 beeps will sound when
a selection is not accepted.
When a selection is accepted, the
indicator light for that selection
comes on and stays on and one
beep will sound. The washer will
use the FABRIC selection (and
options) you selected.
3. When one Indicator Light comes on
but another goes off, this tells you
the second selection has canceled
the first.
For example:
.
lli
If you touch
REG HEAVY,
then touch PERM’T
PRESS, the PERM’T
PRESS selection
will cancel REG
HEAVY.
NOTE: The REG HEAVY indicator
light goes off when the PERMIT
PRESS indicator light comes on.
4. For best fabric care and washabil-
ity maximum and minimum wash
times are preprogrammed for each
cycle. The washer will not accept
less time than the minimum wash
time or more time than the maximum
wash time. (See page 11 for detailed
times.]
CYCLE SIGNALS
End of Wash Signal
r\
The Cycle Signal will beep 5 times
at the end of the WASH CYCLE. This tells
you the wash is done and the load
can be removed.
Deep Rinse Signal
At the beginning of the deep rinse
portion of the cycle, the Cycle Signal
will beep once. This tells you the
washer is filling for the final rinse.
Both signals can be cancelled by
touching the CYCLE SIGNAL pad. The
Cycle Signal Indicator Light will go off.
13