Filter
Top Products
5.
Indicator Lights.
l
The light on eat h selector you touch
~111 glow to show t”lot your selection,ls
recorded They w10 glo\$ urtll the moaa IS
finished
l
Four Indicator Lights below the selec-
tors (SOAK SUPER WASH, WASH, RINSE
2nd RINSE and FINAL SPIN) go on and
off to let you knob what the dasher IS
doing
l
The light on the HOLD Selector glows
when you hove stopped the washer
by touching HOLC
l
The light on the RUN Selector goes off
only when the washer IS OFF, on HOLD,
or during the eight second selection
oerlcd
7
6. Ch anging a selection.
l
Before the washer starts, touch an-
other selector That cancels the one you
don’t want. See page 7 for details.
l
After the washer starts, move the
switch to POWER OFF
- Start back at Step 1
- Or, If you want to drain any water
before making new selectlons
1 Move switch to POWER ON
2
Touch SPIN ONLY
3 Start at Step 1 when spinning
stops
7. HOLD and RUN Selectors.
l
Touch HOLD if you want to stop the
washer for any reason, but want to start
it again where it left off
l
Touch HOLD If you want more than
eight seconds to make selectlons
l
Touch RUN to start the washer only
when It’s on HOLD.
POWER FAILURE. If the electricity
goes off or a fuse blows while the
washer is running, all selections
are canceled. See instructions on
page 7.
To Stop the Washer:
- During spin...touch HOLD or lift
the lid.
-Any time...touch HOLD or
switch to POWER OFF.