Filter
Top Products
Using your Washer
Start vour \vosher If!er VOL put 1~8
detergent the loacl 3rIl arIy other
laundry ads according tc ~7formatlcr~
or pages 3
and ?4
1.
Set the LOAD SIZE SELECTOR.
l
Select the water level that matches
the size of the looa See page 6 for
more lnformatlon
l
To chor,ge the settlrlg cn the LOAD
SIZE SELECTOR,
fl:st move It to RESET
Then move it back to thP setting you
want
2. Move switch to POWER ON.
l
The REG HEAVY Indicator Light will
come on It shows that power IS on and
reminds you t!lat your washer WIII start In
REG HEAVY unless yob iouch o differ
ent
FABWC Selector
l
You have eight seconds to touch o
selector [or to touch the H@LD Selector
for more time)
If
you
do not:
~ The washer will flil with warm water
to the level shown
on
+he
LOAD SIZE
SELECTOR.
-The washer
,wII
select REG HEAVY
(see page 8 for detoi!s)
3.
Touch a FABRIC Selector.
l
Touch selectors on the
lower half.
l
4n ndlcotor light WIII g’ow or ‘he
FABRIC Selector you touched
l
If you want more than eight sec-
onds to make a selection:
~ Touch HC)LD Then take as muc’-
time as vou want
~ Touch a Selector or Selectors
-Touch RUN to cancel HOLD The
washer WIII start to fill eight seconds
after vou touch RUN
4.
Touch OPTION Selectors.
l
If you did not touch a FABRIC
Selector,
you have eight seconds after
the power IS turned on to touch optlop
selectors. The washer will select REG
HEAVY and odd the options you
selected.
The Electronic Controls are pre-set for
a warm wash and cold rinse in every
FABRIC
SelectIon Change water
temperatures by touching Option
l
If you did touch a FABRIC Selector,
you have eight seconds to touch the
option seleciors you want Every time
you touch one, you have eight seconds
to touch
anoiher...UNLESS YOU TOUCH
SPIN ONLY.
SPIN ONLY cancels all
selectlons and starts draining and spin-
ning right away [See page 13 )
l
SOAK CYCLE will cancel any FAB-
RIC Selection touched before it.
l
SUPER WASH can be added to any
FABRIC
Selection Touch tt before the
FABRIC
Selection
l
Touching RINSE SPIN before the
washer starts will cancel all selections
except COLD WASH