Filter
Top Products
For a soak or pre-wash
For best results, use
warm
water
for soaking or prewashing stained
laundry
Hot water can set stains.
1.
Use recommended amount of
detergent or pre-soak product.
2. Push Control Knob in.
3. Turn clockwise to point at
number
in the SOAK Cycle. Use the 4 minute
mark for a pre-wash?
4. Pull Control Knob out. The washer
will start.
5. When the cycle is over, add
detergent for the next selected
wash cycle.
The SOAK Cycle
should always be followed by a
Wash Cycle.
important: See additional care
information on page 7 of your
“Laundry Guide!’
*To start soak or pre-wash with agitation, the Control Knob
must point to a number in the SOAK Cycle.
Liquid bleach dispenser
Always measure bleach. Do not
guess. Never use more than 1 cup
(250 ml) for a full load.
Use less with
lower water level settings. Follow
directions on bottle for safe use. Use
a cup with a pouring spout to avoid
spilling.
1.
2.
3.
Load the washer first.
Pour
measured
bleach carefully
into dispenser.
DO NOT
let bleach
splash, drip or run down into the
washer basket.
Undiluted bleach
will damage any fabric it touche
Start the washer. Bleach will be
diluted automatically during the
wash par-f of the cycle.
For information on bleaching, s
ice “Laundry Guide” page 11.