Whirlpool Gas Dryers Clothes Dryer User Manual


 
Using the automatic cycles
(on some mudds)
Your automatic control senses the dryness of the
load and automatically shuts off when the select-
ed dryness is reached. For the first few loads:
1. Set the cycle Control Knob to point to the
center dot in your automatic cycle.
2. Select a heat setting to match your load.
3. Feel the dried items when the dryer stops.
if the items are d&w than you like, select
a setting closer to LESS DRY the next time
you dry a similar load.
it items are not as dry as you like, select a
setting closer to VERY DRY the next time
you dry a similar load.
The Cycle Control Knob will not move until the
load is almost dry or the cool-down portion of
the cycle has been reached. After the cool
down is complete, the Cycle Control Knob
automatically moves to an OFF area and the
tumbling stops.
NOTE: Your model will not look exactly like the
illustration.
Using the air cycle (no heat)
Fire Hazard
Do not dry plastic or rubber items with heat.
Use the air cycle, or line dry.
Failure to do so could result in fire or dam-
aged items.
The dryer does not heat when the Cycle Control
Knob is set in the air cycle. This cycle can be
used to fluff or air dry bedding, plastic table-
cloths, foam pillows, sneakers, etc.
1. Turn the Cycle Control Knob to the number of
minutes you want in the air cycle. Refer to the
chart below for suggested times.
2. Push the Start Button.
NOTE: Repeat steps above if more time is
needed to dry items.
TYPE OF LOAD
I
CYCLE AND TIME
RUBBER, PLASTIC, HEAT-SENSiTiVE FABRICS
Foam Rubber-Pillows, bras, stuffed toys
PlastioShower curtains, tablecloths
Rubber-backed rugs
Olefin, Polypropylene, Sheer nylon
Air
20-30 min
20-30 min
40-50 min
15-20 min
8